AEM V3 Naturally Aspirated Water/Methanol Injection Kit - 30-3351

AEM V3 Naturally Aspirated Water/Methanol Injection Kit - 30-3351

THE AEM WATER/METHANOL INJECTION SYSTEM ADVANTAGE

Water/methanol injection for forced induction (turbocharged or supercharged) gas-powered race engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation. This allows racers to reliably increase boost and advance ignition timing-without using high-octane racing fuel-for power gains of up to 20%. AEM's Water Injection Kits utilize robust hardware and deliver more advanced features than any other comparably priced water/methanol injection system.

Water/Methanol for All Boost Levels of Forced Induction Gas Race Engines

AEM offers two different water/methanol controller designs for gas vehicles:

One is boost dependent for forced induction vehicles up to 35 PSI of boost Kit PN 30-3300 (1.15 gallon and one injector), Kit PN 30-3301 (5 gallons and two injectors), Kit 30-3303 (two injectors, no reservoir). The Boost Dependent controller has an on-board manifold absolute pressure (MAP) sensor with a molded-in nipple for a boost hose pickup.

The second controller Kit PN 30-3350 (1.15 gallon and one injector), Kit PN 30-3351 (5 gallons and two injectors), Kit 30-3352 (one injector, no reservoir) features a multiple input design that enables users to install AEM's Water/Methanol Injection Kit on ultra-high boost vehicles (above 35 PSI) using a 0-5v voltage-based external MAP sensor.

Note: FOR OPTIMUM RESULTS, ALL WATER/METHANOL INJECTION SYSTEMS AND FLOW GAUGES SHOULD BE RUN WITH AN WMI INLINE FILTER (PN 30-3003). For additional insurance against unintended flow, particularly when the pump and tank must be installed higher than the injections nozzle, we recommend adding our optional High-Flow Low-Current WMI Solenoid (PN 30-3326).

Features:

• Terminated harness features positive lock connector with integrated pump ground circuit and additional wire for optional on/off flow solenoid.
  
• Includes "Boost Safe" readiness failsafe system.
• One machined billet injector with integral check valve to prevent unintended flow.
  
• Recirculation-style pump with integral fittings for quiet operation.
• LED dash light for system status and low fluid warning.
• 20 ft. of high-pressure Nylon injection tubing.

If In stock, AEM products will be dispatched on the same working day. If not in stock, AEM products could take up to 6 weeks to dispatch. Please contact us for a more accurate ETA.